Kazrabei Define with Wi-Fi router characteristics 1. Does the DGS switch have an uplink port? Backbone ports are normally used to connect the Switch to the backbone of your network. Answered on Mar 05, Answer questions, earn points and help others Answer questions.
|Genre:||Health and Food|
|Published (Last):||24 May 2007|
|PDF File Size:||8.15 Mb|
|ePub File Size:||19.36 Mb|
|Price:||Free* [*Free Regsitration Required]|
The Cable Diagnostic function will detect three common faults in an Ethernet cable connecting the Switch to a Page 14 10 seconds. The Switch is then reset for normal operation. It takes about 2 seconds for the Switch to reset.
Since the DGS does not require a power button, plugging its power adapter into a power outlet will immediately power it on. Page Installation This section will explain how to connect Ethernet devices to your new D-Link switch and how to mount the switch.
Before You Connect to the Network The site where you install the Switch may greatly affect its performance. Please follow these guidelines for setting up the Switch. Two mounting slots are provided on the bottom of the switch for this purpose.
Please make sure that the front panel is exposed in order to view the LEDs. Please refer to the illustration below: 1. The end node can be connected to any of the ports of the Switch. Page Troubleshooting Crossover and adjust themselves accordingly to pass data over the network.
What is the maximum length of Category 3, 4 or 5 twisted pair cable that can be used between the DGS and other devices such as routers, switches, computers, etc.? The maximum length of Category 3, 4 or 5 twisted pair cable that can be used between computers and other devices on a network is meters or about feet.
Asynchronous Transfer Mode. Page 21 A port that does not learn device addresses, and that receives all frames with an unknown address. Backbone ports are normally used to connect the Switch to the backbone of your network. Note that backbone ports were formerly known as designated downlink ports.
Page 22 The port on the Switch accepting a terminal or modem connector. It changes the parallel arrangement of data within computers to the serial form used on data transmission links.
This port is most often used for dedicated local management. Medium Dependent Interface. An Ethernet port connection where the transmitter of one device is connected to the receiver of another device. Page 24 Remote Monitoring. Redundant Power System. A device that provides a backup source of power when connected to the Switch. The Switch learns the addresses associated with each switch port and builds tables based on this information to be used for the switching decision.
Page 26 Virtual LAN. A group of location- and topology-independent devices that communicate as if they are on a common physical LAN. Virtual LAN Trunk. VT screens have a text-based appearance. To verify your IP address, please follow the steps below. The replacement hardware need not be new or have an identical make, model or part.
D-Link may, at its option, replace the defective Hardware or any part thereof with any reconditioned product that D-Link reasonably determines is substantially equivalent or superior in all material respects to the defective Hardware.
Page 33 Warranty Period and is subject to the same limitations and exclusions. If a material non-conformance is incapable of correction, or if D-Link determines in its sole discretion that it is not practical to replace the non-conforming Software, the price paid by the original licensee for the non-conforming Software will be refunded by D-Link; Products shall be fully insured by the customer and shipped to D-Link Systems, Inc.
Other trademarks or registered trademarks are the property of their respective owners. Product registration is entirely voluntary and failure to complete or return this form will not diminish your warranty rights. This manual is also suitable for:.
D-link DGS-2205 User Manual
D-link DGS-2205 - Desktop Switch Manuals