During the verification of the implementation, it is noted that the routing tables on R1 and R2 do not include the entry for a remote LAN on R3. Examination of R3 shows the following: 1. Use the network command to configure the LAN network under the global routing process. Restart the OPSFv3 routing process.

Author:Douktilar Tahn
Language:English (Spanish)
Published (Last):25 April 2017
PDF File Size:1.54 Mb
ePub File Size:7.33 Mb
Price:Free* [*Free Regsitration Required]

What are two results of issuing the displayed commands on S1, S2, and S3? Choose two. S2 can become root bridge if S1 fails. S3 can be elected as a secondary bridge. S1 will automatically adjust the priority to be the highest. Which statement describes a characteristic of OSPF external routes? The cost of a type 1 route is always the external cost, regardless of the interior cost to reach that route.

The difference between type 1 and type 2 is in the way the cost of the route is being calculated. By default, how many equal cost routes to the same destination can be installed in the routing table of a Cisco router? Its topology table contains two feasible successors to the same network. What action will the router take? The best alternative backup route is immediately inserted into the routing table.

The DUAL algorithm is recomputed to find an alternate route. The router uses the default route. A network administrator is analyzing first-hop router redundancy protocols. What is a characteristic of VRRPv3? It allows load balancing between routers. VRRPv3 is Cisco proprietary. It supports IPv6 and IPv4 addressing. What is the function of STP in a scalable network? It combines multiple switch trunk links to act as one logical link for increased bandwidth. It protects the edge of the enterprise network from malicious activity.

It disables redundant paths to eliminate Layer 2 loops. Route summarization results in high network traffic and router overhead. Routes within an area are summarized by the ABR. ABRs advertise the summarized routes into the backbone. Which two conclusions can be derived from the output?

There is one feasible successor to network The reported distance to network The neighbor What are the only two roles that permit an OSPF router to be configured for summarization?


CCNA 3 Practice Final Exam Answers 2019 (v5.0.3 + v6.0) – Full 100%

Choose two. The packets are used to discover neighbors that are connected on an interface. The packets are sent as unicast. The packets are unreliable. A set of switches is being connected in a LAN topology. Which STP bridge priority value will make it least likely for the switch to be selected as the root?


CCNA 3 Practice Final Exam Answers 2019-2020 (v5.0.3 + v6.0)

Hello packets are used in both versions to build adjacencies. What are two requirements to be able to configure an EtherChannel between two switches? Choose two. All interfaces need to be assigned to different VLANs. Different allowed ranges of VLANs must exist on each end.


CCNA3 v6.0 Final Exam Answers Option A 100%

Question Which three steps should be taken before moving a Cisco switch to a new VTP management domain? Choose three. Reboot the switch. Reset the VTP counters to allow the switch to synchronize with the other switches in the domain.

Related Articles