Tataur Auditing Consulting Sourcing Training. Link to Active This link will always route to the current Active version of the standard. Enabling you to identify and mitigate the intrinsic risk in your operations, supply chains and business processes. Note 3—The modulus determination is generally based on the use of grip separation as a measure of extension; however, satm desirability of using extensometers, as described in 5. Note 1—Film has been arbitrarily defined as sheeting having nominal thickness not greater than 0. The data is often used to specify a material, to design parts to withstand application force and as a quality control check of materials.
|Published (Last):||11 April 2012|
|PDF File Size:||15.99 Mb|
|ePub File Size:||5.30 Mb|
|Price:||Free* [*Free Regsitration Required]|
This resource is cited by 2 documents show Citations Description This test method covers the determination of tensile properties of plastics in the form of thin sheeting, including film. Scope This test method covers the determination of tensile properties of plastics in the form of thin sheeting, including film less than 1. Note 1 Film has been arbitrarily defined as sheeting having nominal thickness not greater than 0. Note 2 Tensile properties of plastics 1.
This test method may be used to test all plastics within the thickness range described and the capacity of the machine employed. Static Weighing, Constant-Rate-of-Grip Separation Test - This test method employs a constant rate of separation of the grips holding the ends of the test specimen.
Specimen extension may be measured in these test methods by grip separation, extension indicators, or displacement of gage marks. A procedure for determining the tensile modulus of elasticity is included at one strain rate. Note 3 The modulus determination is generally based on the use of grip separation as a measure of extension; however, the desirability of using extensometers, as described in 5.
Test data obtained by this test method is relevant and appropriate for use in engineering design. The values stated in SI units are to be regarded as the standard.
The values in parentheses are provided for information only. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 4 This test method is similar to ISO , but is not considered technically equivalent. ISO allows for additional specimen configurations, specifies different test speeds, and requires an extensometer or gage marks on the specimen.
For assistance with locating previous versions, please contact the information provider.
More D Tensile properties can vary with specimen thickness, method of preparation, speed of testing, type of grips used, and manner of measuring extension. Consequently, where precise comparative results are desired, these factors must be carefully controlled. This test method shall be used for referee purposes, unless otherwise indicated in particular material specifications.
ASTM D882 02 PDF
More D Scope 1. However, for testing specimens in the form of thin sheeting, including film less than 1. Materials with a thickness greater than 14 mm 0.
You are on page 1of 10 Search inside document Standard Test Method for Tensile Properties of Thin Plastic Sheeting1 This standard is issued under the fixed designation D ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon e indicates an editorial change since the last revision or reapproval. These test methods have been approved for use by agencies of the Department of Defense to replace Method of Federal Test Method Standard ISO allows for additional specimen configu- rations, specifies different test speeds, and requires an extensometer or 1. Plastic Specimens4 1. Terminology grip separation as a measure of extension; however, the desirability of using extensometers, as described in 5.